NI USB-9162 DRIVER DOWNLOAD

0 Comment

Message 1 of 6. You can choose labels with pin numbers or signal names or blank labels. This site uses cookies to offer you a better browsing experience. You can program your device using DAQmx in Labview just fine. NI —Servo Drive Interface 6.

Uploader: Voodoosida
Date Added: 14 September 2014
File Size: 29.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 87038
Price: Free* [*Free Regsitration Required]

Back to Top 2. As was first mentioned, this particular module is not supported usb9162 the USB carrier and cannot be programmed to work with it at all.

NI —4-Channel Relay Static. Message 3 of 6.

Please contact us to complete your request. Learn more about our privacy policy.

This site usbb-9162 cookies to offer you a better browsing experience. Use the built-in strain relief holes for BNC devices. Additional Resources Product Documentation: Unfortunately, there is no way to make it just work.

Installing and Configuring USB DAQ Devices

Please note that any additional items included with this equipment such as accessories, ysb-9162, cables, calibration data, software, etc. NI —2-Port High Speed.

See Also  LATITUDE E6320 BROADCOM USH DRIVER DOWNLOAD

Accessing one of these modules using the Scan Mode Interface for CompactRIO severely limits the frequency input range and may cause higher frequency signals to alias.

Before you begin, you must install your application development environment and NI-DAQmx driver software. C Series Module use this udb-9162 Message 4 of 6. Use the supplied strain relief hardware to provide strain relief for your USB cable.

C Series Module Compatibility Chart – National Instruments

After rebooting your computer or adding new hardware to your system, you may see the NI Product Registration Wizard appear. Thread a zip tie through the cable tie mount and tighten around the USB cable. Anyone out there have any luck with this combo? You can program your device using DAQmx in Labview just fine.

Mercury Drive Champaign, IL Refer to Figure 8 for mounting dimensions. You can choose labels with pin numbers or signal names or blank labels. One of our friendly Customer Service representatives will be contacting you shortly with information on when the equipment you requested will be available for viewing. NI —Servo Drive Interface.

See Also  IRIVER SPINN DRIVER

Installing and Configuring USB DAQ Devices – National Instruments

Stock Quick Quote. Learn more about our privacy policy. In windows device manager the NI shows up as “NI no cartridge”. NI —24 V DI.

If you are looking to use the with DAQmx, it is only supported in the cDAQ chassis and only software timing. For guidance on selecting a cable or accessory that is compatible with your: Valid Email Required Item to Inspect: Complete the following steps to install the panel mounting kit on your USBxx device.

We appreciate your interest in using our InstraView website!