INTEL 82579V GIGABIT ETHERNET CONTROLLER LINUX DRIVER DOWNLOAD

0 Comment

The e driver is no longer maintained as a standalone component. Thank you very much! Interfaces files only contain config for loopback When I run lspci -v , this is the info I get for the ethernet card: August 16th, 7. I would suggest actually pulling the latest version from here , and building the modules on your machine so that you have the latest version module.

Uploader: Mezahn
Date Added: 14 January 2009
File Size: 9.22 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 90794
Price: Free* [*Free Regsitration Required]

Support for IntelĀ® V Gigabit Ethernet PHY

August 15th, 4. August 15th, 3. And where did you obtain the intell files? Note The e driver is no longer maintained as a standalone component. Page 1 of 3 1 2 3 Last Jump to page: This forum thread towards the bottom stated that:. I’ll try reinstalling it from SourceForge. Ubuntu Forums Code of Conduct. All hardware requirements listed apply to use with Linux. What I’ve done thus far: We don’t supply patches against the kernel source to allow for static linking of the drivers.

See Also  EPSON RX690 DRIVER

The igb driver supports IEEE time stamping for kernels 2. But I’ll check in the morning! I’ve been digging around forever with this.

Overview The Linux base drivers support the 2. Invalid argument That, of course, looks bad. Did you find this information useful? Super User works best with JavaScript enabled. You can use the insmod command for 2.

Downloads for IntelĀ® 82574 Gigabit Ethernet Controller

August 15th, 6. Channel Bonding documentation can be found in the Linux kernel source: Join Date Aug Beans Intel LM card I’m about to lose my mind over here. Verify that the interface gigabiit. Move the base driver tar file to the directory of your choice.

Not sure if this is helpful after running the second command, perhaps this is the problem? So you’ll need a 2. August 16th, 8. When you ran insmod, did you use the full path to the ko files?

Interfaces files only contain config for loopback When I run lspci -vthis is the info I get for the ethernet card: These drivers are only supported as a loadable module.

See Also  MAG LT765 DRIVER DOWNLOAD

I didn’t include the output from nm-tool because, as I’ve mentioned, I’ve disabled the Network Manager. You can use ethtool version 1. The install location listed above is the default.

But, yes, the same thing happens, my ethernet I don’t use wireless connection seems fine at boot up, then several minutes later, just appears to die.