0 Comment

Audio Output Compliant Standards. Removing the External Memory Module Reverse the above procedure to install an external memory module. Display assembly Section 5. Because of the complexity of the individual boards and subassemblies, do not attempt to make repairs at the component level or modifications to any printed wiring board. Intel Core Duo T 2. Move the real-mode reboot code to an assembly file Comment 15 Alexey Zaytsev

Uploader: Sashicage
Date Added: 6 October 2017
File Size: 67.32 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 45865
Price: Free* [*Free Regsitration Required]

I’m hoping one will be available in the future which might fix this issue. Cables must be handled with extreme care to avoid damage. Disconnect the following cables from the vompaq board: Remove the thermal plate Section 5. At the moment, it will only post if the second core is disabled.

nx7300 – Second Core not activable

Disconnect the fan cable 1 from the system board. Release the keyboard Section 5.

Thermal plate Section 5. Length Thread Width Black 4 3. Regards Comment 13 Alexey Zaytsev I was able to reproduce the problem on one test rig, and there this patch did work as intended.


HP Compaq Business Notebook. Check N computer operation after each replacement: When the confirmation dialog box opens, press f Remove the optical drive 3 from the computer. Disconnect the Bluetooth module cable 3 from the system board. Remove the Mini Card module by pulling the module 3 away from the socket at an angle.

Maintenance and Service Guide HP Compaq nx and nx Notebook PC | Paul Calder –

We reviewed a lot of laptops in Drivers may be in development so please check back at a conpaq date or visit the product homepage. Peter Anvin Reverse the above procedure to install the keyboard. But don’t get your hopes up. Navigation and selection are by keystroke: In all cases, avoid bending, twisting, or tearing cables.

HP Customer Support – Software and Driver Downloads

Make special note of each screw and screw lock size and location during removal and replacement. N External Replace device system works? Lift the front edge of the system board 5 until it rests at an angle. On select computer models, the computer can be reset using the standby switch and either the lid compa or the main power 1.


Anyway, it seems I’ll have to start bisecting now. Lift the front edge of the system board 1 until it rests at an angle. Remove the Bluetooth module 2 from the cover.

Runs the Disk Sanitizer erase cycle once.

If the system has stopped responding and Windows shutdown procedures cannot be used, press and hold for 5 seconds to turn off the ocmpaq. If you install a device and then receive a warning message, remove the device to restore computer functionality. Intel, Celeron, and Core are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries.

The only thing I see is that now you are placing the reboot code in.