If the sim is remote this doesn’t happen; a module resets itself every time a remote sim is connected. SIM nn card used by the Abilis. This device allows to exchange data and sms using an UMTS key. When a continuous or alternate voltage voltange range 2. Jumpers configuration allows to choose between clean contact and opto-isolated digital inputs.
|Date Added:||23 May 2018|
|File Size:||11.39 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
jsb It can be used as backup line when the main one fails, or to establish a connection toward Internet when calling an ISDN number data call back. The PCB version is reported on the case label. The digital outputs can drive any kind of device, accordingly with the electrical specifications.
If the sim is remote this doesn’t happen. Citobox trimmers and pinout. Aethra Starmodem which uses the USB isochronous mode for the downstream.
This device allows to exchange data and sms using an UMTS key. Only the central pins 4,5 and 3,6 are switched! Each input can be manually configured through its corresponding couple of jumpers.
The aetbra and the microphone are decoupled by a transformer. Pins 1,2 and 7,8 are not connected. Jumpers configuration allows to choose between clean contact and opto-isolated digital inputs.
The communication is cut off when the called party hangs up or when the interface timer expires. They are managed by two separated PIC microcontrollers: SIM nn card used by the Abilis.
Abilis software is correctly driving the device. Front Panel and connector pinout. The volume of the microphone and the speaker can be manually regulated with the corresponding trimmers, all of which are externally accessible on the front. Citobox – Front view. One channel device doesn’t require an external power supply. Each output is available both as normally closed and normally open.
It is installed on the board and it’s able to switch each LINE port to the correspondent main port or backup port. Citobox – Block scheme. Each interface of the CITO part is mainly composed of 4 analog pins: Each digital output of the IO part is a volt free contact clean contact and can be driven separately by the Xethra.
Warning Output relays support: Led Meaning State Power Power state. The trimmers allow to regulate the volume of the microphone and the speaker clockwise: This port provides a fast 8-bit bus, where it is possible to connect more slave peripherals. Power is supplied by usb cable ; two channels device require an external 5V-DC power supply. Abilis is not driving the device.
Auxiliary pin, leave disconnected if unused connect to MIC in a special BTicino connection scheme, in order to provide power to the Microphone line.
Physical and electrical specifications.
Jumpers position on PCB. Power is supplied by usb cable .